Andrew Setiawan Rusdianto

Dosen Jurusan Teknologi Hasil Pertanian, Universitas Jember, Jember, Indonesia

Noer Novijanto

Dosen Jurusan Teknologi Hasil Pertanian, Universitas Jember, Jember, Indonesia

Rosy Alihsany

Alumni Jurusan Teknologi Hasil Pertanian, Universitas Jember, Jember, Indonesia

DOI: 

ABSTRACT 

PT. J.A. Wattie is local plantation which process robusta coffee in Jember. The main problem of Indonesian coffee is quality, which can not fulfill the requirement of international market quality. The several factors that influence coffee quality are harvest, sanitation, productionprocesses, place and equipment. Statistical quality control is method to control production process stability, where PT. J.A. Wattie did not apply in coffee productionprocess. The objectives of this research are identify quality output at each stage of processes; observe the correlation of production process and coffee quality based on statistical quality control.Grading and hulling processes according to control chart showed that the process was under control because data plot to be present in interval upper and lower control limit. Pulping and washing processes were out of control because some data plot to be present in outside of upper control limit or lower control limit.Washing process showed other pattern because more than four (4) data make increasing or decreasing pattern. Increasing or decreasing patterns can be indicator of abnormality processes. Abnormality of washing and pulping processes were resulted from the pulper and washer. The rare maintance of pulper and washer can be factor that makes abnormality process.

Keywords: coffee, robusta, quality, statistical quality control

REFERENCES

Achmad F, Rahayu S dan Sumarriani Y. (2010).Penerapan Grafik- X dan Grafik- R sebagai Grafik Kendali dalam Pengujian Kualitas Air.J. Standardisasi 12 (1): 14 – 19.

BSN [Badan Standardisasi Nasional] (1999). SNI 01-2907-1999, Biji Kopi. Jakarta: Badan Standardisasi Nasional.

Haming M dan Nurnajamuddin M (2007). Manajemen Produksi Modern Operasi Manufaktur dan Jasa. Jakarta: Bumi Aksara.

Irvan, Hanum Z dan Ruknimi (2006). Pendendalian Mutu Produk dengan Metode Statistik.J. Sistem Teknik Industri 7 (1): 109-117.

Lindsay WM dan Evans JR(2007).Pengantar Six Sigma. Jakarta: Salemba Empat.

Mitra A(1993). Fundamentasi of Quality Control and Improvement. New York: Mc Milan Publishing.

Najiyati S dan Danarti (2004).Kopi: Budi Daya dan Penanganan Pascapanen. Edisi Revisi. Jakarta : Penebar Swadaya.

Puslit Koka [Pusat Penelitian Kopi dan Kakao Indonesia] (2007).Menaikkan Kualitas Kopi dan Kakao.(http://www.pikiran-rakyat.com/cetak/2005/0105/27/cakrawala/profil.htm). Diakses tanggal 15 Desember 2007.

Tampubolon MP(2004). Manajemen Operasional. Jakarta: Ghalia Indonesia.